|
ARTICLE
III. DISTRICTS
DIVISION 2. RESIDENTIAL DISTRICTS
Sec. 24.1-323. R20-Medium density single-family
residential district.
(a) Statement of intent. The intent of
the R20 district is to provide opportunities for medium density single-family residential
development. Its intended application is for areas designated medium density by the
comprehensive plan where public utilities are available.
(b) Dimensional standards. Each lot created or used shall be subject to
the following dimensional standards:
R20-SINGLE-FAMILY RESIDENTIAL DISTRICT
Use
Classification |
Minimum
Lot Requirements (1) |
Minimum
Yard Requirements |
Maximum
Building Height (2) |
| |
Area |
Width |
Front |
Side |
Rear |
|
Single-Family
Detached Dwellings |
20,000
sq. ft.
1850m2 |
100’
30m |
40’
12m |
15’
4.5m |
30’
9m |
40’
12m |
All Other
Permitted & Special Uses |
20,000 sq.
ft.
1850m2 |
100’
30m |
40’
12m |
15’
4.5m |
30’
9m |
35’
10.5m |
(1)
These minimum lot requirements apply where both public water and public sewer are
available. For lots not served by public water and public sewer, refer to Section
24.1-204.
(2)
For dwelling
units in excess of thirty-five feet (35’) [10.5m] in height, refer to Section
24.1-233.
Minimum district size: none
NOTE:
Residential open space subdivision techniques may be used in this district
Performance standards and special use permit requirements or conditions
may increase yard and lot requirements. See article IV. |
(Ord. No. O97-17, 6/4/97) |