|
ARTICLE
III. DISTRICTS
DIVISION 2. RESIDENTIAL DISTRICTS
Sec. 24.1-322. RR-Rural residential district.
(a)
Statement of intent. The RR
district is intended to provide opportunities primarily for single-family residential
development generally having a maximum density of one dwelling unit per acre. Low density
development is appropriate in areas where public services and facilities are limited
and/or physical or environmental constraints are prevalent.
(b)
Dimensional standards. Each lot created or used shall be subject to
the following dimensional standards:
RR-RURAL RESIDENTIAL DISTRICT
Use
Classification |
Minimum
Lot Requirements(1) |
Minimum
Yard Requirements |
Maximum
Building
Height(2) |
| |
Area |
Width |
Front |
Side |
Rear |
|
Single-Family
Detached Dwellings |
1
ac
4000 m2 |
150’
45m |
50’
15m |
20’
6m |
50’
15m |
35’
12m |
All Other
Permitted & Special Uses |
1 ac
4000 m2 |
150’
45m |
50’
15m |
20’
6m |
50’
15m |
35’
10.5M |
(1)
These minimum lot requirements apply where both public water and public sewer are
available. For lots not served by public water and public sewer, refer to Section
24.1-204.
(2) For dwelling
units in excess of thirty-five feet (35’) [10.5m] in height, refer to Section
24.1-233.
Minimum district size: none
NOTE:
Residential open space subdivision techniques may be used in this district.
Performance standards and special use permit requirements or conditions may increase yard
and lot requirements. See article IV. |
(Ord No. O97-17, 6/4/97;
Ord. No. 08-17(R), 03/17/09) |